After the tower factory determines the ground assembly method

2022-06-28

After the tower factory determines the ground assembly method, it should do a good job in the selection and matching of tools, and should also check carefully before use, and unqualified tools should not be used.
(4) When assembling, the iron tower factory should pay attention to the installation position of the foot nails. When there is no special requirement, it can be carried out as follows:
1) Linear tower. Facing the power receiving side, the foot nails are set on the back leg.
2) A straight tower with high and low legs. The foot pegs are arranged on the lower leg side.
3) Corner tower. Facing the power receiving side, the foot peg is set on the right rear leg when the left corner is turned; the foot peg is set on the right rear leg when the right corner is turned.
(5) The strength of the wire cross arm and the ground wire bracket must meet the requirements of the design drawings. For example, if there are lengths on both sides of the cross arm of the corner rod: the long section is on the outer corner side, and the short section is on the inner corner side; On the contrary, it is generally arranged as such.
(6) If there are no special design requirements for the penetration of bolts in the tower factory, it should be implemented in accordance with GBJ 233-1990 "Code for Construction and Acceptance".

Relevant News

Matters to be considered in tower ground assembly1

2022-06-28

We have a professional QA team to ensure all products we sell are meet clients’ requirements.

2022-05-26

Quality assurance and Quality control are the most signification section that we focus on.

2022-05-26

Through a corporate initiative

2022-05-26